Water as also been the main source for all our health problem.
Hence storing water in sump with hygienic conditions is very important.
GRP Sectional Panel Tanks are constructed of panels made from SMC
(Sheet Molding Compound) by hydraulic hot press under high temperature (150℃)
and pressure conditions to maintain the best endurance.
Using stainless steel for the interior structure and plated steel for the exterior,
the panel Exhibits excellent resistance to erosion.
Easy insllation with on-site bolt assembly and Tank shape and
volume can be freely Designed with no restrictions based on site location,
weather or climate.
It is possible to make the GRP panels in a variety of colours. In most cases,
however, this Type of tank is installed in the open, exposed to direct sunlight.
If the GRP panels are Transparent, the growth of algae and other
micro-organisms would be accelerated.
SMC has adopted panel to minimize this problem, completely opaque and
does not permit the passage of any light through it.
A typical problem with steel tanks has always been the high thermal
conductivity and expansion of coefficient of steel.
These characteristics can cause loosening of the panel connecting bolts
in areas of wide temperature change.
|Water Quality||Water Tightness||durability||Easy Assembly||Expension Potential||Maintenance|
|SMC Panel type Water Tank||◎||◎||△||◎||○||◎|
|Concrete Water Tank||X||△||△||△||X||X|
|STS, Steel||Welded tyoe Water Tank||△||○||○||○||△||X|
|Panel type Water Tank||△||△||○||X||○||X|
|GRP Hand-lay up Water Tank||X||○||X||○||X||X|
From small tanks to large, SMC panel can fit virtually any order.
Tank sizes are selectable to fit each need and desire,
SMC tank can be installed to Handle from 0.25(㎥) up to NO LIMIT !
Various sized panels can make the below tanks that utilize the most horizontal &
perpendicular space and also can be used as home use small tanks & Big ones.
In other type tanks, water pressure can open the joints breaking the seal,
and allowing the stored
In accordance with SS245:1995 Specification for
Glass Reinforced Polyester Sectional Water Tank.
Test Pressure : GHP × 6 = 2.4bar (9.81 × 4 × 1,000 ×) / 10.6
protects water condensation on the outside of the tank and minimizes
temperature variation of the stored water.
SMC TANK with long experience and technology on SMC products.
It maintains soft itself and adhesives even at low temperature.
The combined flange thickness at the panel joints is sufficient to meet any stress imposed.
This self sealing feature eliminates the possibility of separation and hence prevents leakage of the tank.
It’s very useful to take a maintenance inside of water tank.